硫化温度对ZnS薄膜生长质量的影响  被引量:2

Effect of Sulfurization Temperature on the Growth Quality of ZnS Thin Film

在线阅读下载全文

作  者:宋力刚[1,2] 朱特[2] 曹兴忠[2] 张仁刚[1] 况鹏[2] 靳硕学[2] 张鹏[2] 龚毅豪 王宝义[2] 

机构地区:[1]武汉科技大学理学院,武汉430000 [2]中国科学院高能物理研究所,北京100049

出  处:《原子核物理评论》2017年第3期651-655,共5页Nuclear Physics Review

基  金:国家自然科学基金资助项目(11505205;11505192);湖北省教育厅科研计划项目(D20121109)~~

摘  要:采用热反应法对玻璃衬底上以磁控溅射制备的Zn薄膜进行硫化,制备出Zn S薄膜。薄膜的微观结构、物相结构和表面形貌分别采用正电子湮没技术(PAT)、X射线衍射仪(XRD)、扫描电子显微镜(SEM)进行分析和表征。利用慢正电子湮没多普勒展宽对四个不同硫化温度下得到的ZnS薄膜样品中膜层结构缺陷进行研究,测量了薄膜中的空位型微观缺陷的相对浓度,指出445℃硫化样品中正电子注入能量在1.5~4.5 keV后S参数最小,说明该硫化温度下反应生成的ZnS薄膜结构缺陷浓度最小,膜的致密度最高。XRD结果显示薄膜在445℃以上硫化后,呈(111)择优生长趋势。从扫描电镜的结果也可以看出,在445℃硫化后,薄膜的晶粒明显地变得更大、更致密,这是因为ZnS晶胞比Zn晶胞大以及硫化过程中ZnS固相再结晶的缘故。Zn S thin films have been prepared by sulfurizing zinc thin films deposited on glass substrate by magnetron sputtering for two hours. The microstructure defects, crystallizations and surface morphology of zinc films sulfurized at different temperature were analyzed by PAT(positron annihilation technique), XRD(X-ray diffraction) and SEM(Scanning electron microscopy), respectively. For analyzing the structure defect of four samples with different sulfurization temperature, PAT has been used to obtain the relative concentration of defects.With the positron energy range of 1.5~4.5 keV, the S parameter of Zn S films is minimum. It demonstrates that Zn S films produced at 445 ℃ have the minimum structural defect concentration and the highest density. XRD results show that films are blende structure with the preference of(111) orientation above 445 ℃. And from the result of SEM, because of Zn S films recrystallization, the crystal grains obviously become large and dense at 445 ℃.

关 键 词:硫化锌薄膜 磁控溅射 硫化 正电子湮没谱学 

分 类 号:O782.7[理学—晶体学]

 

参考文献:

正在载入数据...

 

二级参考文献:

正在载入数据...

 

耦合文献:

正在载入数据...

 

引证文献:

正在载入数据...

 

二级引证文献:

正在载入数据...

 

同被引文献:

正在载入数据...

 

相关期刊文献:

正在载入数据...

相关的主题
相关的作者对象
相关的机构对象