高分子核壳微球补强架空线路绝缘恢复涂覆料与配网带电作业机器人作业匹配性研究  

Compatibility of Insulation Recovery Coatings for Overhead Lines Reinforced with Polymer Core-Shell Microspheres and Live Working Robots in Distribution Networks

作　　者：郑永立[1,2] 赵悦菊 张黎明[3] 滕济林 徐善军[1,2] 宁昕[4] 俞葆青 刘兆领[3] 王立国 马辰腾 ZHENG Yongli;ZHAO Yueju;ZHANG Liming;TENG Jilin;XU Shanjun;NING Xin;YU Baoqing;LIU Zhaoling;WANG Liguo;MA Chenteng(Beijing Guodian Futong Science and Development Co.,Ltd.,Beijing 100070;NARI Group Corporation,State Grid Electric Power Research Institute,Nanjing 211106,Jiangsu;State Grid Tianjin Electric Power Company,Tianjin 300010;State Grid Corporation of China,Beijing 100017)

机构地区：[1]北京国电富通科技发展有限责任公司,北京100070 [2]南瑞集团有限公司(国网电力科学研究院有限公司),南京211106 [3]国网天津市电力公司,天津300010 [4]国家电网有限公司,北京100017

出　　处：《有机硅材料》2022年第6期8-13,共6页Silicone Material

基　　金：国家电网有限公司科技项目(SGTJBHOOYJJS1902138)。

摘　　要：分别采用气相法白炭黑及聚丙烯酸丁酯(PBA)/聚甲基丙烯酸甲酯(PMMA)核壳微球制备了架空导线绝缘恢复涂覆料,对3种核壳比的PBA/PMMA微球分别开展透射电镜及红外光谱分析,结果表明壳结构占比低于30%后,核壳结构不完整;以气相法白炭黑制备的电缆涂覆料的力学性能及介电强度更佳,但涂覆过程中与配网带电作业机器人的协同施工性差,无法实际应用。以PBA/PMMA核壳微球配制的电缆涂覆料具有良好的施工性,当微球的核壳比为60/40时,涂覆料的性能较佳,其密度为0.96 g/cm^(3),拉伸强度为3.18 MPa,撕裂强度为7.51 kN/m,介电强度为21.32 kV/mm,能够满足架空导线绝缘恢复的技术要求,涂覆过程中与配网带电作业机器人的协同施工性较好。The insulation recovery coatings for overhead conductors were prepared by fumed silica,butyl polyacrylate(PBA)and polymethyl methacrylate(PMMA)core-shell microspheres respectively.The PBA/PMMA microspheres with three core-shell ratios were analyzed by transmission electron microscopy and infrared spectroscopy.The results show that the coatings has incomplete core-shell structure when its shell structure proportion is less than 30%;the cable coatings has a better mechanical properties and electrical strength prepared with fumed silica,but the coating process is poor when coordinating with the live working robot of the distribution network and cannot be practically applied.The cable coatings with PBA/PMMA core-shell microspheres have good workability.When the core-shell ratio of the microspheres is 60/40,the coatings has better performance,whose density is 0.96 g/cm^(3),the tensile strength is 3.18 MPa,the tear strength is 7.51 kN/m,and the electrical strength is 21.32 kV/mm,which meet the requirements for the insulation recovery of overhead conductors,and has good synergistic construction with the distribution network live working robot in the process.

关 键 词：绝缘恢复 高分子核壳微球 涂覆料 硅橡胶 配网带电作业机器人 

分 类 号：TQ333.93[化学工程—橡胶工业]