检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]华南理工大学土木与交通学院,广东广州510641 [2]深圳市城市交通规划设计研究中心有限公司,广东深圳518021
出 处:《交通运输工程学报》2012年第6期97-103,共7页Journal of Traffic and Transportation Engineering
基 金:国家自然科学基金项目(61203164;61174184);广东省自然科学基金项目(S2012040007998);中央高校基本科研业务费专项资金项目(2011ZM0117)
摘 要:建立了信号控制方案过渡前后的交叉口相位差调整量关系方程组,针对各交叉口过渡信号周期的允许取值范围,利用交叉口相位差调整比例的极小极大原理,提出了单周期对称调节过渡算法与N周期加权调节过渡算法。分析结果表明:单周期对称调节过渡算法将在满足一次过渡条件下,实现交叉口相位差实际调整量最大值的最小化;N周期加权调节过渡算法则可以综合考虑各交叉口过渡信号周期的不同允许取值范围,根据交叉口相位差最大调整比例的最小化要求,通过N个过渡信号周期最终实现协调控制方案的快速平滑过渡。与其他过渡算法相比,N周期加权调节过渡算法实现了对于控制区域内交叉口相位差调整量的整体优化,使过渡方案能够更好地满足不同信号交叉口的控制需求,具有更广的适用范围与实用性。The equations describing the relationship of phase difference adjustment quantities were established for intersection before and after transition. Considering the allowable range of each intersection's signal cycle length in transition period, the single-cycle symmetrical adjustment transition algorithm and the N cycle weighted adjustment transition algorithm were proposed based on the minimax principle of offset adjustment ratio. Analysis result shows that when the symmetrical adjustment transition algorithm is finished in one cycle, and the actual maximum adjustment of intersection phase difference is minimized. The weighted adjustment transition algorithm comprehensively consideres the allowable range of each intersection's transition signal cycle, and can make a coordinated control scheme rapidly and smoothly transit to a new coordinated control scheme after N transition signal cycles based on the minimum requirement of the maximum adjustment ratio of phase difference. Compared with other transition algorithms, the global optimization of phase difference adjustment for all intersections in control area can be realized by the weighted adjustment transition algorithm, which better satisfy the controldemands of different signal intersections, so the weighted adjustment transition algorithm is more practical and has a broader application scope. 2 tabs, 7 figs, 16 refs.
关 键 词:信号控制 过渡算法 极小极大原理 加权调节 相位差 协调控制
分 类 号:U491.54[交通运输工程—交通运输规划与管理]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.121