检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:胡轶[1] 何彦刚[2] 岳红维[3] 刘玉岭[2]
机构地区:[1]新疆师范大学,化学化工学院,乌鲁木齐830054 [2]河北工业大学微电子研究所,天津300130 [3]中国电子科技集团公司第五十四研究所,石家庄050081
出 处:《半导体技术》2015年第6期436-440,472,共6页Semiconductor Technology
基 金:国家中长期科技发展规划02科技重大专项资助项目(2009ZX02308);河北省自然科学基金资助项目(F2012202094);新疆师范大学博士科研启动基金资助项目(XJNUBS1226);华东理工大学煤气化及能源化工教育部重点实验室开放基金资助
摘 要:研究了精抛液中各组分对Cu/Ta去除速率的影响。在分别考察磨料质量分数、Ⅱ型螯合剂、活性剂和双氧水等各组分对Cu/Ta去除速率的影响后,研发了磨料质量分数为2%,Ⅱ型螯合剂体积分数为0.35%,活性剂体积分数为2%,H2O2体积分数为2%的FA/O精抛液。并在MIT854布线片上进行了精抛测试。结果显示,精抛12 s之后,100-100线条处高低差从精抛前的76.7 nm降低为63.2 nm,而50-50线条处高低差从精抛前的61.3 nm降低为59.8 nm。并且,经过FA/O精抛液精抛后粗抛后产生的尖峰也有所减小,台阶趋于平坦。精抛后,100-100和50-50处的高低差均小于70 nm,能够达到产业化指标。The components of fine polishing slurry, including abrasive concentration, chelating agentⅡ,active agent and H2O2 effect on removal rate of Cu / Ta were investigated respectively. Based on these researches,an FA / O fine polishing slurry was developed with a mass fraction of 2% abrasive,the volume fraction of 0. 35% chelating agentⅡ,the volume fraction of 2% active agent and the volume fraction of 2% H2O2. Then the FA / O fine polishing slurry was tested on the MIT854. The results show that the step-height of 100- 100 line width was reduced from 76. 7nm to 63. 2nm,and 50- 50 line width reduced from 61. 3nm to 59. 8nm after 12 s finishing polish. The spikes caused by rough polishing were also decreased and the steps were more planar. Through FA / O fine polishing,the height-difference of line width with 100- 100 and 50- 50 were all less than 70 nm,which meet the demand of industry requirement.
关 键 词:化学机械平坦化 精抛 FA/O精抛液 Cu/Ta 去除速率
分 类 号:TN305.2[电子电信—物理电子学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.222