检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:张智铭 仪淑敏 李学鹏 步营 牟伟丽 于建洋 劳敏军 励建荣 ZHANG Zhi-ming;YI Shu-min;LI Xue-peng;BU Ying;MU Wei-li;YU Jian-yang;LAO Min-jun;LI Jian-rong(College of Food Science and Technology,Bohai University,National&Local Joint Engineering Research Center of Storage,Processing and Safety Control Technology for Fresh Agricultural and Aquatic Products,Collaborative Innovation Center of Seafood Deep Processing,National R&D Branch Center of Surimi and Surimi Products Processing,Jinzhou 121013,China;Penglai Jinglu Fishery Co.,Ltd.,Yantai 265600,China;Taixiang Group,Rongcheng Taixiang Food Products Co.,Ltd.,Ministry of Agriculture Key Laboratory of Frozen Prepared Marine Foods Processing,Weihai 264309,China;Zhejiang Industrial Group Co.,Ltd.,Zhoushan 316100,China)
机构地区:[1]渤海大学食品科学与工程学院,生鲜农产品贮藏加工及安全控制技术国家地方联合工程研究中心,海洋食品精深加工关键技术省部共建协同创新中心,国家鱼糜及鱼糜制品加工技术研发分中心,辽宁锦州121013 [2]蓬莱京鲁渔业有限公司,山东烟台265600 [3]泰祥集团-荣成泰祥食品股份有限公司,农业部冷冻调理海洋食品加工重点实验室,山东威海264309 [4]浙江兴业集团有限公司,浙江舟山316100
出 处:《食品工业科技》2021年第1期42-47,53,共7页Science and Technology of Food Industry
基 金:国家重点研发计划资助(2018YFD0901004)。
摘 要:本论文以未漂洗金线鱼鱼糜为研究对象,分析了不同压力、保压时间对金线鱼鱼糜凝胶强度、TPA、持水性、蒸煮损失、白度、pH及微观结构的影响。结果表明,凝胶强度随压力增加而增加,随保压时间的增加呈现先增加后降低的趋势,300 MPa时达到最大值1150.71 g·mm,20 min时达到最大值1355.17 g·mm。经过超高压处理的鱼糜凝胶硬度均高于热处理的鱼糜凝胶硬度,在300 MPa和20 min时达到最大值。持水性随压力增大先增加后降低,在300 MPa时达到最大值72.72%,30 min时达到70.23%,继续处理变化不明显。蒸煮损失率随压力增大先降低后增加,300 MPa时达到最小值17.88%。随着压力的升高,凝胶的白度值逐渐增加,500 MPa时最高,相比200 MPa增加14.29%;随着保压时间的增长,白度值逐渐增加,在60 min时达到最大。在300 MPa和20 min时鱼肠内部网格结构最为致密,孔隙均匀。In this paper,the effect of different pressure and dwell time on the gel strength,TPA,water holding capacity,cooking loss,whiteness,pH and microstructure of Nemipterus virgatus surimi were studied.The results showed that the gel strength increased with the increase of pressure and increased first and then decreased with the increase of dwell time,and reached the maximum value of 1150.71 g·mm at 300 MPa and reached the maximum value of 1355.17 g·mm at 20 min.The hardness of surimi gel treated by ultrahigh pressure was higher than that of heat treated surimi gel,and reached the maximum at 300 MPa and 20 min.The water holding capacity first increased and then decreased with the increase of pressure,reached the maximum value of 72.72%at 300 MPa,and 70.23%at 30 min.The continuous treatment did not change significantly.The cooking loss rate first decreased and then increased with the increase of pressure,reaching the minimum value of 17.88%at 300 MPa.With the increase of pressure,the whiteness of gel increased gradually,and reached the maximum value at 500 MPa,which increased by 14.29%compared with 200 MPa.With the increase of dwell time,the whiteness value increased gradually and reached the maximum at 60 min.At 300 MPa and 20 min,the mesh structure of fish sausage was the most compact and the pores were uniform.
分 类 号:TS254.1[轻工技术与工程—水产品加工及贮藏工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.71